Kitchen-Knife
Hammer
Cardboard
Scissors
Yarn
Glue
Tin Foil
Tape
Card-stock
Ruler
Pencil
1) Begin by removing the blade from your kitchen knife. To do this, I took my knife to my patio with a hammer. I held the knife by the blade against the concrete with the sharp side of the blade touching the cement. I then carefully struck the handle with the hammer along its seam where the two pieces of the handle join around the handle.
2) Using your ruler, draw a basic T-Shape on a sheet of card-stock that is approximately 5 inches long and 3 at its widest part. Cut out the T-Shape and then fold it in half and using your scissors, cut the T-Shape in to a symmetrical design. This will be the pattern for the handle of your athame.
3) Trace your pattern on the cardboard four times and cut each piece out.
4) Glue the blade you removed from the kitchen knife between two of the cardboard cut-outs. Make sure you use lots of glue. You may want to lay the knife on a flat surface and place something heavy on top of it.
5)When it is dry, glue the second two pieces just as you did the first two. Allow to dry.
6) When this is dry, there is bound to be some shifting of pieces so trim the handle so that it has a clean edge and that the both pieces of cardboard are even.
7) Now hold the Athame for a few minutes to get an idea for how it will feel in your hand. Does the handle feel too long? Would you rather then edges be rounded or have corners? Trim and adjust as desired, although I wouldn't attempt to get too detailed and fancy in my design.
8)Wrap tin foil around the handle shaping it as desired. When you are done, wrap the handle with tape to hold it all together.
9) Finally, wrap the entire handle with yarn (your choice of color). You can wrap the entire handle with one long piece of yarn, getting as close to the tips as possible. When you are done, you can wrap the tips in a spiral pattern to cover the handle completely by smearing the tip with glue first and carefully laying down the yarn.
10) When you have wrapped the entire Athame you can coat it with several coats of glue allowing it to completely dry between coats. When the glue dries it will harden.
11) Finally, paint the handle with a clear lacquer to seal everything. If you desire you can paint the handle a specific color before sealing with lacquer.
12) If you desire, you can then take a sharpening-stone and sharpen the dull side of the blade so that they are even. However, I like the idea that one side is sharp and the other side is dull, creating a balance of opposites.
Books in PDF format to read:
Howard Phillips Lovecraft - The Tree On The HillHoward Phillips Lovecraft - The Shadow Out Of Time
Labels: greater solomon 2 witch person cleansing house blessing under torture witches condemned witch tools black magic occult altar ritual powerful deadly spells arcana typohunt gods pagan witches queries
